What are the ways to look at the quality of valve grinding for valve equipment?
Date of release:2018-08-13 Author:Tiansheng Click:
There are four ways to view the quality of the valve and seat sealing surface of the valve device: visual inspection, pencil line drawing, oil bearing blue view and seal tester view.
Intuitive viewing
The valve seat can be slightly impacted by the valve, and the embossing investigation can be performed after taking out the valve, which is determined by the width of the embossing and the touch condition. When the touch is wide or the touch is poor, the valve and valve port should be trimmed from the beginning or the valve port should be replaced until the seal is outstandingly stopped.
Use a pencil to evenly mark the valve working surface (each 3~4mm) with a certain number of lines and the valve seat working surface touch, roll 1/4~1/3 turn, take out the valve, and the surrounding seals are blocked or evenly, about 1.2 ~1.5mm wide. Explain that the seal is good, otherwise it should be ground from scratch.
Tu Hongdan Oil Method
Valve device
Usually, the repairing unit adopts this method, applying a thin bearing blue or red dan oil to the valve cone surface, putting it into the valve seat, holding the valve disc by hand, and rolling the valve several times, and taking it out after investigation, if its bright ring is not Intermittent, indicating that the seal is outstanding, otherwise it should be ground from scratch.
Valve air tightness view
Gas test method: use airtight tester, usually used in a larger repair shop, such as the pressure of the barometer does not decrease, indicating that the air tightness is excellent.
Oil test method: In the usual small repair shop and car unit, put the valve into the valve port and pour the clean fire oil to the valve plate just over. Wait 10-15min to investigate whether the oil surface is lowered or not. Is there any oil oozing out? If it is confirmed that the airtightness of the air valve is not good, the sealing surface should be ground from the head; if not, the airtightness of the valve and the valve port is outstanding. For qualified valves, they should be clean and clean, coated with oil, and placed in the cylinder head valve seat in order to prevent corrosion, mistakes or loss.
The address of this article:http://www.draft-evolution.com/en/news/396.html
Key word:氣門磨床,氣門車床,氣門設備
The next one:Reaming method for valve seat of valve device
Recently browse:
Related products:
Related news:
- How to make the industry of valve lathe processing rise
- Safety precautions for using valve lathes
- Tell me more about how the valve lathe controls the operation.
- Learn about the independent entry and exit of the valve lathe system
- The steps and methods of valve machine fault handling are nothing more than
- So how should the principle and function of the valve device be understood?
- Tiansheng Xiaobian explains to you the classification of engine variable valve equipment intake
- What adjusts the clearance of the valve lathe?
- Main features of welding of rod end drilling machine for valve equipment
- Talk about the special equipment for the valve starting and starting the valve